C. Crane Twin Coil Ferrite Instruction Manual download pdf (Page 23)

CCRadio2E Page 23

Troubleshooting Guide

The CCRadio2E will not turn on and none of the buttons work:

The Lock Switch, located on the right side of the radio between the

tuning and the volume knobs, is in the up position. Push the switch

down to release the lock and resume normal operation of the radio.

(Please see Lock Switch on page 16.)

The CCRadio2E comes on by itself or changes to a different

station while I’m listening:

The Timer has been set. The word TIMER will appear in the display if

the Timer is set. To cancel the Timer setting, press and hold the

Timer/Set button until you hear a short beep and the word TIMER

disappears from the display.

My radio shuts off after just a few seconds:

Low batteries can cause this situation. Replace them with a new set of

batteries. If the radio is operating on the power cord, check for solid

connections at the wall outlet and the back of the radio. Also make sure

there is power at the wall outlet.

Stations won’t hold in memory:

The memory button settings are being overwritten. When recalling a

station from memory, if you hold the memory button down too long it will

program the current station over your previously stored station. To recall

a station that has been stored in memory, always press and release the

button quickly. To program a new station into memory, tune to the

desired station and then press and hold the memory button for two

seconds until you hear a beep. Also, please see the section on Memory

Tuning on page 11.

The AM reception is poor inside of my building:

Many building materials have adverse effects on AM band listening.

Brick, concrete, stucco, and aluminum siding all have a tendency to

absorb or reflect the AM signal. Spanish tiles or metal roofs are also

culprits. To test your AM reception, put batteries in your radio and take it

outside of the building, especially at night. If your reception is notably

stronger outside than inside the building, an external AM antenna may

be necessary to bring the signal into the building. See the AM Tuning

and Listening Tips section on page 26 for a quick and easy antenna.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

No comments

C. Crane Twin Coil Ferrite Instruction Manual Page 23