C-crane CC Solar Observer Radio User Manual download pdf (Page 7)

CC Solar Observer Page 7

Getting Started –Powering Your Radio

Power by Charging Adapter (optional accessory not included) —

Connect the AC charging adapter between a 120Volts/60Hz wall outlet and

the “BATTERY PACK CHARGING JACK” on the side of radio (see location

of jack on page 5). To fully charge the battery pack, keep the charging

adapter plugged in overnight. When the battery pack is fully charged, the

radio should play for over 15 hours.

Note: The AC charging adapter should only be used to charge the battery

pack and should not be used to power the radio on a constant basis.

Leaving the charging adapter plugged into the radio for long periods of

time will shorten the life of the internal battery pack.

Internal

Battery Pack

Fold Out

Solar Panel

Install 3 “AA”

batteries as

shown here.

Inserting Batteries:

1. Position the radio face down on a soft surface to protect it.

2. Remove the battery compartment cover.

3. Insert the 3 “AA” cell batteries into the compartment, as indicated in the

picture below. Be sure the negative (-) end is against the spring.

Refer to the picture below to insure correct installation of your batteries.

4. Replace the battery cover. On the front of the radio, slide the “Power

Switch” to “Battery” to turn the radio on.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

C-crane CC Solar Observer Radio User Manual Page 7